Pages: [1]   Go Down
Author Topic: printing file from IDE is erratic  (Read 647 times)
0 Members and 1 Guest are viewing this topic.
oak ridge, TN, USA
Offline Offline
Newbie
*
Karma: 0
Posts: 20
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I usually have to exit the IDE (ver. 0016) in order to print my source file.
The fault is that the correct number of pages come out of the printer completely blank unless I close the IDE and restart the IDE.  Then it prints normally.  The may be an quirk of my setup, but it never occurs with other apps.

Also a suggestion:  It would be nice to be able to select alternate fonts for printing.  It would also be nice to print only selected text instead of the whole file.
Logged

Seattle, USA
Offline Offline
Full Member
***
Karma: 0
Posts: 248
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I noticed the same thing (MacOS X version) and it is still a problem in 0017.

And I agree with the suggestions for improvement. The default font is far too big (even for my aging eyesight). If I want to print something, I usually open it in BBEdit and print from that application.
Logged

.andy

Pages: [1]   Go Up
Jump to: