Pages: [1]   Go Down
Author Topic: designing and testing  (Read 608 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi,
      this is polisetty,i designed old version serial arduino(ATMega8) hardware board as per you schematic,but it's not working.My main confusion is which version arduino software is used and pc configaration also ,how to installed and how 2 use????. i used serial type with MAX232.please give support to me.
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 637
Posts: 34599
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Do you have a bootloader in your AVR chip? You need one.
Check the board is working as a chip with just the boot loader in will flash the LED on Pin13, if you don't have a LED here just look at the pin on an oscilloscope.

Quote
version arduino software is used

I would use the latest.

Quote
and pc configaration also

If you are using the built in COM ports then nothing to configure.

Quote
but it's not working.

So what messages do you get when you try?
Logged

Pages: [1]   Go Up
Jump to: