Pages: 1 [2]   Go Down
Author Topic: Arduino 021 resets wrong USB  (Read 2785 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Tesla Member
***
Karma: 148
Posts: 9753
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

An explination may be that the IDE communicates with the arduino USB chip and not a virtual serial port established by the USB chip. If the USB chips have the same identifier, both may be treated as one.
Logged

Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   smiley-cool

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 362
Posts: 17308
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
An explination may be that the IDE communicates with the arduino USB chip and not a virtual serial port established by the USB chip. If the USB chips have the same identifier, both may be treated as one.

That sounds like a promising path to consider. Tell FTDI to get their driver s#$% together.

Lefty
Logged

0
Offline Offline
Sr. Member
****
Karma: 0
Posts: 375
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think this goes back to the rxtx lib.  I don't have a problem since switching to eried's patch.

http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1237179908
Logged

North Yorkshire, UK
Offline Offline
Faraday Member
**
Karma: 104
Posts: 5531
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
I think this goes back to the rxtx lib.  I don't have a problem since switching to eried's patch.

http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1237179908
Hmm, perhaps. I have to admit I have not really experienced a slow IDE so I have not tried that yet. I'll try it soon then.

Mowcius
Logged

Pages: 1 [2]   Go Up
Jump to: