Loading...
« previous topic   next topic »
Pages: 1 [2]   Go Down
Author Topic: Rant about manufacturing quality  (Read 3685 times)
0 Members and 1 Guest are viewing this topic.
CrossRoads
Global Moderator
Boston area, metrowest
Online Online
Brattain Member
*****
Karma: 247
Posts: 16534
Available for Design & Build services
View Profile
WWW
« Reply #15 on: January 17, 2011, 02:17:39 pm »
 Bigger Bigger Smaller Smaller Reset Reset
So you were you able to successfully resolder the pin & remove the solder blobs?
Logged
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17

noctrl
on the long way north
Offline Offline
Newbie
*
Karma: 0
Posts: 8
Arduino rocks
View Profile
« Reply #16 on: January 19, 2011, 05:58:46 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Looking at that picture; I would say many if the pins in the upper row needs re-soldering.
Perhaps all solder points. The solder look "sugared" and would not last long.

I would say that is a defective board.  :smiley
Logged

wossname
0
Offline Offline
Jr. Member
**
Karma: 1
Posts: 82
Uno momento
View Profile
« Reply #17 on: January 22, 2011, 05:45:54 am »
 Bigger Bigger Smaller Smaller Reset Reset
CrossRoads: I soldered that loose pin in place but I left the blobs on there, they don't seem to be causing any trouble and nobody actually seemed to think they should need removing anyway.
Logged

Pages: 1 [2]   Go Up
Print
« previous topic   next topic »
 
Jump to: