Pages: 1 [2]   Go Down
Author Topic: Rant about manufacturing quality  (Read 7985 times)
0 Members and 1 Guest are viewing this topic.
Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 538
Posts: 27144
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

So you were you able to successfully resolder the pin & remove the solder blobs?
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

on the long way north
Offline Offline
Newbie
*
Karma: 0
Posts: 8
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Looking at that picture; I would say many if the pins in the upper row needs re-soldering.
Perhaps all solder points. The solder look "sugared" and would not last long.

I would say that is a defective board.  :smiley
Logged

0
Offline Offline
Jr. Member
**
Karma: 1
Posts: 82
Uno momento
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

CrossRoads: I soldered that loose pin in place but I left the blobs on there, they don't seem to be causing any trouble and nobody actually seemed to think they should need removing anyway.
Logged

Pages: 1 [2]   Go Up
Jump to: