Go Down

Topic: Rant about manufacturing quality (Read 9318 times) previous topic - next topic

CrossRoads

So you were you able to successfully resolder the pin & remove the solder blobs?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

noctrl

Looking at that picture; I would say many if the pins in the upper row needs re-soldering.
Perhaps all solder points. The solder look "sugared" and would not last long.

I would say that is a defective board.  ::)

wossname

CrossRoads: I soldered that loose pin in place but I left the blobs on there, they don't seem to be causing any trouble and nobody actually seemed to think they should need removing anyway.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy