Go Down

Topic: USB connector pins reversed in schematic (Read 1 time) previous topic - next topic

I've discovered (the hard way) that the USB pins on the arduino schematic are mapped backwards.

They should be:
Pin:     Function:
1         +5V
2         USB data -
3         USB data +
4         GND

But unfortunately in power/gnd and the two data lines are reversed, which then reverses the pins on the board layout.

So if you are going to develop something based on the arduino board schematic, then just be sure to disconnect the connector in the schematic, flip it, and then reconnect it.



Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy