Go Down

Topic: connect two ardui (Read 1 time) previous topic - next topic

lenzfr

Hi I am trying to build  serial connect between two arduino baords with radio connection.

The recipient module gets values from 0V to 0,8 V. So I boosted up the signal that 0V stays 0V (digital 0) and everything grater than 0,6 becomes ~ 5V (digital 1).

Is it correct that the serial input (RX) accepts ~0V als logigal 0 and ~5V als 1??

Thanks for your help!

kuuk

i couldn't find information on the site but see Mellis' answer here :
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1159424394

Arduino or the Atmega8 on it uses TTL serial, which is ~0V and ~+5V for LOW/HIGH.

kuk

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy