Go Down

Topic: connect two ardui (Read 1 time) previous topic - next topic


Hi I am trying to build  serial connect between two arduino baords with radio connection.

The recipient module gets values from 0V to 0,8 V. So I boosted up the signal that 0V stays 0V (digital 0) and everything grater than 0,6 becomes ~ 5V (digital 1).

Is it correct that the serial input (RX) accepts ~0V als logigal 0 and ~5V als 1??

Thanks for your help!


i couldn't find information on the site but see Mellis' answer here :

Arduino or the Atmega8 on it uses TTL serial, which is ~0V and ~+5V for LOW/HIGH.


Go Up