Go Down

Topic: connect two ardui (Read 1 time) previous topic - next topic


Hi I am trying to build  serial connect between two arduino baords with radio connection.

The recipient module gets values from 0V to 0,8 V. So I boosted up the signal that 0V stays 0V (digital 0) and everything grater than 0,6 becomes ~ 5V (digital 1).

Is it correct that the serial input (RX) accepts ~0V als logigal 0 and ~5V als 1??

Thanks for your help!


i couldn't find information on the site but see Mellis' answer here :

Arduino or the Atmega8 on it uses TTL serial, which is ~0V and ~+5V for LOW/HIGH.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131