Go Down

Topic: When to press RESET (Read 431 times) previous topic - next topic


I'm not sure how helpful this may be, but for those who make their own "serial Arduinos", it could be.

When uploading a sketch, I was never sure when I should press the RESET button. I found that if an LED is put between the receive line and +5, it will flash once at exactly the right time to press RESET.

Rx --|<--/\/\/\-- Vcc
       ^   (1K)

I used a high value of resister so it would not interfere with the transmission.

"Data is not information, information is not knowledge, knowledge is not understanding, understanding is not wisdom."
~ Clifford Stoll

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131