Go Down

Topic: Attiny84 board (Read 1 time) previous topic - next topic

harry

May 21, 2009, 02:05 pm Last Edit: May 21, 2009, 02:06 pm by harrod159 Reason: 1
Hi all,

I want to use the luminet IDE with the Attiny84 so i've put together a board for use on breadboard. Its the same width as an atmega32 (dip40), and has a voltage reg to 3.3v, pin headers for all pins and a programming connector. I havent put on a header for the ftdi cable yet, next revision!

Can someone look at it and tell me if i've made any glaring ommisions or errors before i have it fabbed up?

Thanks!
http://www.flickr.com/photos/38604845@N02/3551444552/in/photostream/

http://www.flickr.com/photos/38604845@N02/3551444552/in/photostream/

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy