Pages: [1]   Go Down
Author Topic: Burning Mega bootloader with a JTAGICE mkII  (Read 623 times)
0 Members and 1 Guest are viewing this topic.
Seattle WA
Offline Offline
Full Member
***
Karma: 1
Posts: 208
Arduino rocks
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm working on a project, and my AVRISP died an untimely death. The only programmer I was able to borrow on short notice is a JTAGICE mk II, and I can't seem to find a Mega bootloader binary or instructions on how to burn it using the JTAGICE. The Arduino IDE won't talk to it. Anyone got any good suggestions?
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 597
Posts: 33304
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
The Arduino IDE won't talk to it

Not surprised as JTAG is an entirely different thing. You can use JTAG but it is a totally different command set. Se section 30.9 of the ATmega640/1280/1281/2560/2561 data sheet.

However, I have not seen anyone who has done this and written it up.
Logged

Pages: [1]   Go Up
Jump to: