Go Down

Topic: uno 328p & dataman pro+ (Read 197 times) previous topic - next topic

biocustomconsoles

Hello, at work we use dataman to program ic's. We got a lot of black 328p  in and I made a optiboot rig with a uno. Works great with the ide program after loading boot.
If I program a ic with the dataman then put back into uno, its works but I can no longer use ide program.
keeps giving the sync errors and the rx tx  blink not in sync.  If I reload optiboot on ic then works again.

What setting on dataman program do I need to set up to be able to use both programs? Thanks

CrossRoads

Once you put on Optiboot, then the chip is expecting sketches to be uploaded using the Serial port.  If you program via the SPI pins, that overwrites the boot area and there is no bootloader to look for sketches from the serial port.
So you need to create a file that has both optiboot and the program together.
This was discussed in the forum last week.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

spycatcher2k

Sounds like you are not setting the lock fuse after bootloading them.
Drew.
http://www.uk-pcb.co.uk - My UK Based PCB Fab & Assembly Company
Design work undertaken
SMD & Thru-Hole assembly

HugoPT

Quote
Sounds like you are not setting the lock fuse after bootloading them.

I don't think so.
The CrossRoads answer  is more accurate
Debian,Mint,Ubuntu
Arduino Mega 2560
Arduino Nano
Arduino Duemilanove
MAC OS Montain Lion
Raspberry PI Model B

spycatcher2k

OK - Misunderstood the problem.
Drew.
http://www.uk-pcb.co.uk - My UK Based PCB Fab & Assembly Company
Design work undertaken
SMD & Thru-Hole assembly

biocustomconsoles

Ok. I will look it up. I try search here on dataman but didn't find nothing about this.

Go Up