Pages: [1]   Go Down
Author Topic: Help with a 1.27mm pin connection, please  (Read 621 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 46
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I just picked up a SHT75 sensor from sensitron and it came on a 4 pin board with the pins spaced 1.27mm.  I want to connect each pin a 22awg wire preferrably using a connector.  Is that possible?  Can someone please help me find the appropriate connector.  I'm a bit lost...

The datasheet also says the sensor should not be soldered (1.2 on page 4), is it possible to use a connector without soldering?

The exact dimensions of the pins are on the datasheet here: http://www.sensirion.com/en/pdf/product_information/Datasheet-humidity-sensor-SHT7x.pdf


Thank you much,
Jacob
Logged

Pages: [1]   Go Up
Jump to: