Go Down

Topic: Arduino based UHF pager network - POCSAG encoding (Read 950 times) previous topic - next topic

RandallWright

Aug 03, 2010, 10:09 pm Last Edit: Aug 04, 2010, 04:07 am by RandallWright Reason: 1
Before I start too seriously on my project, is anyone else working on an arduino based UHF radio to send a signal to a pager using POCSAG encoding?

I don't want to run a PC with this setup.

I would like to be able to monitor different pieces of hardware  like a windmill, and if it goes down or starts acting up I would like to be notified via pager.

I would also like to have access to my Arduino via radio frequency for any admin operations and upgrades.

Thanks!

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview