Go Down

Topic: 10PU vs. 20PU ? (Read 990 times) previous topic - next topic

ironbot

Hi,
I setup to first time burn bootloader into an Atmega168 10PU, and I failed :D

Could it be for the standard chip coming with my original Arduino board was a 20PU?


Jeff K

The 20PU is rated to run at 20MHz while the 10PU is rated for 10MHz max.  The standard Arduino bootloader is designed for 16MHz.  Trying to load it on a 10PU could cause a problem.  I would try loading the lilypad bootloader that is designed to run at 8MHz.  If that fails, then you ruled out the bootloader.
Jeff K - JKDevices.com - home of the MegaMini

ironbot

Thank you for the clear answer!

Go Up