Pages: [1]   Go Down
Author Topic: What are the RX/TX pins the GSM library uses in the Mega2560  (Read 2571 times)
0 Members and 1 Guest are viewing this topic.
Turku
Offline Offline
Full Member
***
Karma: 1
Posts: 228
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

This is a silly question but I have problems with a GSM shield. It's RX and TX are clearly marked but software defines those in the Mega. I will cross TX and RX of course. That is, RX goes to the TX and vice versa. Arduino's documentation is meant to be easy but it confuses me when there is no mention of TX and RX.

So, when I use GSM library, what is RX on the Mega2560 and what is TX.
Logged

Madrid (Spain)
Offline Offline
Full Member
***
Karma: 0
Posts: 137
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

These are the pins used:

Transmission pin: 3
Receive pin: 10
Receive interrupt: 4
Logged

Pages: [1]   Go Up
Jump to: