Pages: [1]   Go Down
Author Topic: Does EAGLE have this shrouded male pin header?  (Read 1557 times)
0 Members and 1 Guest are viewing this topic.
Central MN, USA
Offline Offline
Tesla Member
***
Karma: 64
Posts: 6889
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm trying to make a design that needs 10 pins so here's what I want to use:


Does EAGLE have a part like this? I searched for a bit and didn't find anything. Thanks.

BTW, found this spec sheet at jamece:
http://www.jameco.com/Jameco/Products/ProdDS/67812.pdf

Do you think this is same as the one in the picture?
Logged


SF Bay Area (USA)
Offline Offline
Tesla Member
***
Karma: 106
Posts: 6371
Strongly opinionated, but not official!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Library "pinhead" has a 2x5 male connector WITHOUT the shroud...
Logged

Central MN, USA
Offline Offline
Tesla Member
***
Karma: 64
Posts: 6889
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thankw westfw. I'm getting some parts for a new project. I'll get some of these connectors and take an exact measure once I get them. Right now, I just have a rectangle in the keepout layer to remind myself not to invade its space.
Logged


Pages: [1]   Go Up
Jump to: