Pages: [1]   Go Down
Author Topic: TFT / LCD module development for Arduino  (Read 1087 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 1
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I'm bussy to develop a tft / lcd module for the Arduino. This module will have a TFT onboard and and a controller onboard, witch can be controlled with a SPI interface.

The code for the lcd controller will be avaible for free and can be used.

In this forum I would like to have ideas from you witch format the TFT must be and if a touch panel must be added.

My own format idea was a 4.7" tft with 480x272 with a touch panel.

I like to hear from you and any idea is welcome.
Logged

Central MN, USA
Offline Offline
Tesla Member
***
Karma: 65
Posts: 6938
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Souds like a Good plan. Arduino doesn't have much memory so your chip has to have a sd card slot. To be honest I donnot like full color display with the arduino since it is just not meant for it. The most complicated display I am willing to use is a mono dot matrix one. IMHO
Logged


Pages: [1]   Go Up
Jump to: