Go Down

Topic: Using RS232 on the USB board for display control? (Read 1 time) previous topic - next topic

fabian

Hello!

I have the USB version 2.0 of the Arduino board. We want to control a LCD display with it - it obviously can read RS232-based commands for the cursor and so on - is there any tutorial - or anybody ;) - who can help us?

...thanks!
Fabian

David Cuartielles

Hej Fabian,

the fact is that on the one hand, you could use the pins 0 and 1 as serial I/O if you are not using the communication back to the computer.

On the other hand I have to anticipate that we are working on a Software version of the serial port that would allow you to have serial communication on any pin. This will be ready for Arduino-0004.

I know :-) we haven't even release Arduino-0003, but it is going to be out there in more or less a week. And version 4 will be out in a bit more than a month.

/David

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy