Go Down

Topic: Can't program firmware (Read 11909 times) previous topic - next topic

jdanoz

it is mandatory to connect the AC adaptor (9, 12v) ??? or only the isp to parallel... ??

now i'm going to try with this programmer (ispprog)...

jdanoz

it's strange...

i had tested all cases... plug the power supply and try uisp and avrdude... without power supply... etc, and no luck...

yesterday, i tested the ispprog... and it works! but later i tested the uisp one more time (for test) and the error "flash error at...xxx) not showed!!!!!

now i have my arduino board working!

thanks!


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy