Go Down

Topic: Can't program firmware (Read 14974 times) previous topic - next topic


it is mandatory to connect the AC adaptor (9, 12v) ??? or only the isp to parallel... ??

now i'm going to try with this programmer (ispprog)...


it's strange...

i had tested all cases... plug the power supply and try uisp and avrdude... without power supply... etc, and no luck...

yesterday, i tested the ispprog... and it works! but later i tested the uisp one more time (for test) and the error "flash error at...xxx) not showed!!!!!

now i have my arduino board working!



Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131