Go Down

Topic: Normal Behaviour after a Reset? (Read 557 times) previous topic - next topic

trauts

I am trying to get my new board (sticker #4652) working (with either OSX 10.3.9 or 10.4.7). When I press the reset button (held down for ~2 seconds) then release, I get 3 different responses. (Note that this new board has an LED associated with pin 13)

when powered by USB, with jumper set appropriately.
least common - >  1. Quick flash on Tx & Rx, and the LED-pin-13, then no further visible action.
                           2. LED-pin-13 rapid, bright flashing
most common - >  3. LED-pin-13 lights up dimly


When powered by 9V battery (USB cable disconnected)
1. no visible activity
2. LED-pin-13 rapid, bright flashing

Is this normal behaviour? Which mode is the one I should see before uploading?
Thanks, Stuart

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview