Pages: 1 2 [3]   Go Down
Author Topic: Programmer is not responding on Serial Arduino  (Read 4048 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 17
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

just received my arduino/usb 168 today..  and had the dreaded  error " programmer not responding " was caused my pc assigning a com17, i went into control panel/ system / devices / preferences / advanced forced com2..
rebooted..
started development environment arduino 0007, options com2 and atmega186 (not mega8)

short depress of reset switch, quick 3 blinks, and then clicked download bingo the tx rx lights were flashing and i'm up and working

Binary sketch size: 3676 bytes (of a 7168 byte maximum)

C:\MicroContoller\arduino-0007\tools/avr/bin/uisp -v=4 -dpart=atmega168 -dprog=stk500 -dserial=/dev/com2 -dspeed=19200 --upload if=C:\Documents and Settings\xxx\My Documents\Arduino\led_blink\applet\led_blink.hex

Binary sketch size: 3676 bytes (of a 7168 byte maximum)

[ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff] . [ff]   [20] }
Receive: { . [14] . [10] }
Transmit: { Q [51]   [20] }
Receive: { . [14] . [10] }

(total 4116 bytes transferred in 3.80 s (1083 bytes/s)
Firmware Version: 1.15
Firmware Version: 1.15
Logged

Forum Administrator
Offline Offline
Newbie
*****
Karma: 3
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

are you sure you selected the atmega168 from the menu?


this
Binary sketch size: 3676 bytes (of a 7168 byte maximum)
means the code was compiled for the atmega8

Logged

Pages: 1 2 [3]   Go Up
Jump to: