Go Down

Topic: Bootloader problem (Read 350 times) previous topic - next topic

Hello everyone,
I was trying to burn the bootloader using STK500, following the tutorial posted in the playground section. It seems that the bootloader is not responding to the program. I have some questions:
1) There are some bootloaders which send some characters to the computer. If I burn Arduino's bootloader and observe a terminal emulation program after reset, should I expect something on it? Please tell me the settings for the program also.
2) Is there something else I have to take care about while burning through STK500 not mentioned in the tutorial.
I am extremely sorry if similar queries are posted on the forum. I read the FAQ and did some search, but couldn't find something related.
Regards,
Dragonofages

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy