Pages: [1]   Go Down
Author Topic: Bootloader problem  (Read 303 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello everyone,
I was trying to burn the bootloader using STK500, following the tutorial posted in the playground section. It seems that the bootloader is not responding to the program. I have some questions:
1) There are some bootloaders which send some characters to the computer. If I burn Arduino's bootloader and observe a terminal emulation program after reset, should I expect something on it? Please tell me the settings for the program also.
2) Is there something else I have to take care about while burning through STK500 not mentioned in the tutorial.
I am extremely sorry if similar queries are posted on the forum. I read the FAQ and did some search, but couldn't find something related.

Pages: [1]   Go Up
Jump to: