Pages: [1]   Go Down
Author Topic: Arduino USB revision C  (Read 490 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I just got a Revision C of Arduino USB.  Sorry, I am a newbie, but I was trying to upload a sketch blink.  I coulnt get it worked after installing the usb drivers, setting it to com 1, baud 9600, atmega168.  I also noticed that there is no LED on path of pin 13.   I got my board from Sparkfun.  Is there something I did wrong?

Michael
Logged

Daniel
Guest
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi

Do you have the latest version of the Arduino software?
I ask because there is no serial speed setting in Arduino 7, except in the Serial Monitor, which you don't need for uploading the blink sketch.

D
« Last Edit: February 25, 2007, 10:51:11 pm by Daniel » Logged

Forum Administrator
Cambridge, MA
Offline Offline
Faraday Member
*****
Karma: 11
Posts: 3538
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Also, the bootloader on the Arduino board operates at 19200, so if you've been editing the baud rate in your Arduino preferences file, it should be set to 19200.
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think Rev C doesnt come with the LED along pin 13.  I think that threw me off.  I changed the usb com port to 2, and it seemed to work fine.  No, blinking but thats fine.  I just need to solder on a LED.

Thanks for the help.

Quote
Also, the bootloader on the Arduino board operates at 19200, so if you've been editing the baud rate in your Arduino preferences file, it should be set to 19200.
Logged

Pages: [1]   Go Up
Jump to: