Go Down

Topic: Arduino BT bootloader problem (Read 295 times) previous topic - next topic

ycmark

Hello,

I am new to arduino as well as hardware. Recently, my arduino BT suddenly fails to be detected and programmed in windows, and I found out the reset pin(pin 7) always go high and low repeatly. I decide to upload the bootloader using the Parallel Port Programmer http://www.arduino.cc/en/Hacking/ParallelProgrammer?from=Main.ParallelProgrammer.

And I follow the step decribed in here
http://www.uchobby.com/index.php/2007/09/12/how-to-update-the-arduino/
with replaced the bootloader to bt one.

My problem is that I always face verification error

avrdude: verifying ...
avrdude: verification error, first mismatch at byte 0x3800
        0x0c != 0xff
avrdude: verification error; content mismatch

avrdude: safemode: hfuse changed! Was df, and is now ff
Would you like this fuse to be changed back? [y/n]

What should I do?

Thanks a lot,
Mark

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy