Binary sketch size: 1110 bytes (of a 14336 byte maximum)avrdude: stk500_getsync(): not in sync: resp=0x30avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
you need to use +5Vgroundrx and txtry swapping rx/tx also, in case its a labeling issue.
...I'll grab my 5v power supply and see if it works better...
Did you try the suggestions in the troubleshooting guide (http://www.arduino.cc/en/Guide/Troubleshooting#upload)? Do you have any other Arduino boards? Can you upload to them?
Also, try the final Arduino 0010 release: http://www.arduino.cc/en/Main/Software
There is an LED on the board. It does a triple flash on powerup, waits ~10 seconds, and repeats the triple flash. (and repeats the 10 second wait, triple flash, etc...)
Have you tried the 2nd configuration but switching TX/RX?
avrdude: stk500_recv(): programmer is not respondingavrdude: stk500_recv(): programmer is not responding
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16