Pages: [1]   Go Down
Author Topic: what's wrong?  (Read 281 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 1
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I've got a litlle problem with my Arduino NG.
Something went wrong, don't know what.

When I connect my arduino via usb and try to upload a sketch, I hit reset and the pin 13 led light blinks very fast a couple of times and then the TX an RX leds lite up.
after that I get the following message:

Atmel AVR ATmega8 is found.
Uploading: flash
Firmware Version: 1.18
Firmware Version: 1.18
Programmer is not responding


Then if I hit the reset button again nothing happens at all and I only get the "Programmer is not responding." message.

I realy have no clue on what steps to take to find out what's wrong, so all help is welcome.


thanks!



Logged

Forum Administrator
Cambridge, MA
Offline Offline
Faraday Member
*****
Karma: 12
Posts: 3538
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Check the troubleshooting guide.  What operating system are you on?  Have you installed new software recently?  What did you have connected to the board?
Logged

Pages: [1]   Go Up
Jump to: