Go Down

Topic: which *uino board to use? (Read 378 times) previous topic - next topic


I'd like to make tool for identifying multiple wires using an arduino "transmitter" board and a laptop or pda(preferrable) "receiver".  Basically, I'd like to run a coded signal through up to 10 different wires (each lead is a valve station) at around 12V (I'm pushing signal through 14 gauge wire over 500' sometimes) with a single common.

I'm wondering which board would be the best platform to base this project on.  Any suggestions?  I'd also like to power the transmitter side with batteries.



If you plan to talk to a PDA you will probably want to stay with a serial *duino

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131