Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Xbee Shield Version 2 from NKC Electronics  (Read 191 times)
0 Members and 1 Guest are viewing this topic.
pd2kplus10
0
Offline Offline
Jr. Member
**
Karma: 0
Posts: 50
Arduino rocks
View Profile
« on: October 29, 2008, 10:19:12 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hello everyone,

I'm having a problem finding info on the version 2 xbee shield from NKC. I bought 2 of these a few months back. I'm now starting to play with them. I'm kind of leery about inserting my xbee modules into them right now ... since I don't know what jumpers J1 & J2 do. I plugged the shield onto my arduino ... can't seem to read any voltage off the shield. Zero volts from GND to 3v3 on the shield.

Anyone else having this problem?


thanks,
Phil
Logged

Franklin
Lacomb, Oregon
Offline Offline
Sr. Member
****
Karma: 0
Posts: 297
View Profile
« Reply #1 on: October 29, 2008, 08:32:10 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Have you checked with NCK yet? That's where I'd start. Look at the documentation.
Logged
Stephen

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: