Go Down

Topic: Xbee Shield Version 2 from NKC Electronics (Read 374 times) previous topic - next topic

pd2kplus10

Hello everyone,

I'm having a problem finding info on the version 2 xbee shield from NKC. I bought 2 of these a few months back. I'm now starting to play with them. I'm kind of leery about inserting my xbee modules into them right now ... since I don't know what jumpers J1 & J2 do. I plugged the shield onto my arduino ... can't seem to read any voltage off the shield. Zero volts from GND to 3v3 on the shield.

Anyone else having this problem?


thanks,
Phil

Franklin

Have you checked with NCK yet? That's where I'd start. Look at the documentation.
Stephen

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy