Pages: [1]   Go Down
Author Topic: How to program Arduino Due from Atmel Studio 6.2?  (Read 517 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Dear Members,

I require help, and guidance. I have compiled a LED blinking code for Arduino Due (AD) board in Atmel Studio 6.2. Now I have to program the hex file on AD board.

Please guide what steps I have to take to program Arduino Due board from Atmel Studio 6.2? There are much links to guide, programming other Arduino boards from Atmel Studio, but I have found none link/info on how to program Arduino Due board from Atmel Studio.

Thanks

AZDeen
Logged

Venezuela
Offline Offline
God Member
*****
Karma: 17
Posts: 523
Ground, ground, always ground
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

You can use the .bin file generated by AS6 located at:
Quote
...Documents\Atmel Studio\6.1\YourProject\Yourproject\Debug\

Then load your .bin file to Arduino Due using bossac.exe that comes with
the Arduino IDE (...\arduino-1.5.6-r2-windows\arduino-1.5.6-r2\hardware\tools) as follows (cmd command line):

Quote
bossac.exe --port=COM12 -U false -e -w -v -b yourfile.bin -R

Notice that I am using port 12 because that is the port in my laptop where my Due is connected.

Remember to press the delete and reset buttons of Arduino Due before run the bossac.

Good luck!

p
Logged

Pages: [1]   Go Up
Jump to: