Pages: [1]   Go Down
Author Topic: question regarding arduino eagle files  (Read 4683 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 36
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,
i didn't know where to put this question. hope this is the right place.
i looked at the arduino smd files and i attache zoom in on the atmega328 package.
the layer t-stop has some overlap between the pads. this means that all the pads will be short no?
or i don't understand exactly what this t-stop layer does.
can somebody please help me with this?
thanks,
Etay


* Untitled.png (88.08 KB, 650x529 - viewed 32 times.)
Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 212
Posts: 8967
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The tStop (top Stop) and bStop (bottom Stop) layers mark areas that don't get solder mask.
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Pages: [1]   Go Up
Jump to: