Pages: [1]   Go Down
Author Topic: 32ch servo controller  (Read 210 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, is there anyone experience This torobot 32ch servo controller?can i use Arduino software on this chinese broad?
If yes , i needed help to know the setup of this board from how to use torobot software to executed and run.
I have read all manul Instruction and don't understands...  smiley-roll-sweat
I have test connected servo and run the software but servo keep runing one direction verytime i executed :smiley-roll-sweat:baud9600,.
I think i really needed a step by step learing.. please let me know any site or link for me to follow...
I really needed you guy professional knowledge....

Hope I'm not posting to the wrong site smiley-confuse
Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 212
Posts: 8974
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have test connected servo and run the software but servo keep runing one direction verytime i executed

What do you mean by "keep runing one direction"?  A servo will have a physical stop and can only turn about 180 degrees.

Did you read this article? http://www.bajdi.com/torobot-32-channel-servo-controller/
And this article: http://letsmakerobots.com/content/arduino-and-chinese-32-channel-servo-controller
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks for your reply John.
sorry for my bad English. .. smiley-sweat maybe I should take a video to show you.
hope you can advise..
Logged

Pages: [1]   Go Up
Jump to: