Go Down

Topic: 32ch servo controller (Read 391 times) previous topic - next topic

Magmarco

Hi, is there anyone experience This torobot 32ch servo controller?can i use Arduino software on this chinese broad?
If yes , i needed help to know the setup of this board from how to use torobot software to executed and run.
I have read all manul Instruction and don't understands...  :smiley-roll-sweat:
I have test connected servo and run the software but servo keep runing one direction verytime i executed :smiley-roll-sweat:baud9600,.
I think i really needed a step by step learing.. please let me know any site or link for me to follow...
I really needed you guy professional knowledge....

Hope I'm not posting to the wrong site :~

johnwasser


I have test connected servo and run the software but servo keep runing one direction verytime i executed


What do you mean by "keep runing one direction"?  A servo will have a physical stop and can only turn about 180 degrees.

Did you read this article? http://www.bajdi.com/torobot-32-channel-servo-controller/
And this article: http://letsmakerobots.com/content/arduino-and-chinese-32-channel-servo-controller
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Magmarco

Thanks for your reply John.
sorry for my bad English. .. :smiley-sweat: maybe I should take a video to show you.
hope you can advise..

Go Up