Go Down

Topic: On & Off Switch (Read 680 times) previous topic - next topic


I'm almost done with my LM35 temperature sensor project and need to make an on & off switch.  What is the best way to do this?
Do I put the switch on the positive side or the negative side?
Also is there a way to turn the entire Arduino on & off if using a wall plug that will always be plugged in but not easily accessible?


I think sv1 will switch the power from the plug to the serial/usb port. You could replace this with a switch.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131