Go Down

Topic: Trouble with ENC28J60 ethernet shield set up (Read 427 times) previous topic - next topic

paulr

Can anyone help with getting this compatible shield up and running I bought it from Ekitszone Electronics (Hong Kong) for my Duemilanove ATMEGA328 board (Arduino 0016).
I am pitifully ignorant of networking.
The shield uses a library very similar to the Nuelectronics board and I use a notebook under Win XP.
I have not been able to communicate with the shield and supect I am failing to use the correct MAC, ip and baseurl addresses:

I plug in the cable between notebook and Shield and power it all from the computers usb port. My ISP allocates a dynamic IP address. I have no problem networking two computers in a LAN (direct RJ45 cable connection) with intenet connection but I cannot get a connection
to the ethernet shield.
My ISP allocates a dynamic IP.
I would be very grateful for any suggestions!
Thanks in advance, paulr.

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview