Go Down

Topic: Bootloader problem (Read 327 times) previous topic - next topic

dragonuv

Nov 10, 2009, 03:40 pm Last Edit: Nov 10, 2009, 03:41 pm by dragonuv Reason: 1
I got myself a new Atmega168 and placed it in the arduino. When I tried burning the bootloader with the usbtinyisp I see led 13 blinking every second and it never stops doing it.

whenever I try to upload a sketch it says:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
It acts as if there is no microcontroller on the arduino board.

btw, whenever I upload a sketch with the usbtinyisp it is all going well, but I needed it to burn the bootloader so I could use the Serial library, which is impossible without the arduino board.

I would be grateful if someone could help me with this.
Thanks!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy