Pages: [1]   Go Down
Author Topic: Arduino StripBoard [problem]  (Read 457 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Full Member
***
Karma: 0
Posts: 139
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, i've tried to do this
 

this is what i have





is there anything that looks wrong ?
Cause i got the power led working.. but the pin 13 (blinking led) doesnt light up... smiley-sad
I've measured the GND and AVCC and got 5v
Any help/tips would be apreciated. thank you
Logged

Lancashire, UK
Offline Offline
Edison Member
*
Karma: 8
Posts: 1992
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The socket is back to front, which doesn't matter provided you put the chip in to back to front in the socket so its right with the circuit.
Logged


Netherlands
Offline Offline
Sr. Member
****
Karma: 1
Posts: 290
(:-)
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Do you have a programmed atmega (with bootloader)?
« Last Edit: July 31, 2010, 11:19:13 am by wortelsoft » Logged

0
Offline Offline
Full Member
***
Karma: 0
Posts: 139
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, it's programmed smiley-wink
but... nevermind, i already fixed it!
There was an error in the schematic.. the resistor must be connected to the + side of led (pin13).. instead of the negative - as the image shows.

Now everything is working fine!
Thank you anyway.
Logged

Pages: [1]   Go Up
Jump to: