Go Down

Topic: Pro mini problems (Read 306 times) previous topic - next topic

maxheald

Hello, I am having some problems with my Pro mini 328. I soldered some straight headers onto the breakout pins on the side and right angle headers on the programming pins. I cannot upload a sketch because it says "not in sync". Also when power is applied to the board the default blink starts, but then increases in frequency exponentially until it just stops... I used a no clean flux pen to solder and this is what happened. So i tried to clean with alcohol carefully with a tooth brush, and it didn't help..

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy