Go Down

Topic: upload errors and not a programmer help (Read 578 times) previous topic - next topic

0001mike

I have been trying to upload a test pattern to a 4x4 cube we built to get it to work no luck can i get a little help ?

ChilliTronix

So your uploading code we haven't seen to a board you haven't told us about to get a pattern on a "cube" where we don't know how it is wired, where you have not told us what it is supposed to be doing or what it is doing, and you are expecting an answer based on what exactly?

In short.... no one can help on the basis of the information you have so far provided.

nickgammon

Which Arduino? Which cube? What error message did you get?
Please post technical questions on the forum, not by personal message. Thanks!

More info: http://www.gammon.com.au/electronics

Henry_Best

#3
Nov 09, 2014, 04:27 am Last Edit: Nov 09, 2014, 04:28 am by Henry_Best
So your uploading code we haven't seen to a board you haven't told us about to get a pattern on a "cube" where we don't know how it is wired, where you have not told us what it is supposed to be doing or what it is doing, and you are expecting an answer based on what exactly?
You mean that you, like me, failed the mind-reading skills 101 examination?   :)

KenF


Henry_Best

You need to fix that.
I would, but I can't find an accredited course anywhere.

KenF

I would, but I can't find an accredited course anywhere.
They don't advertise.  If you don't know where they are, you failed their entrance criteria :)

Go Up