Pages: 1 [2]   Go Down
Author Topic: Help - Arduino + 4 DC Motors  (Read 4120 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Faraday Member
**
Karma: 16
Posts: 2855
ruggedcircuits.com
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

If the motors work independently on each controller then my guess is something wrong with your wiring. Please take a few minutes and sketch something out for us to refer to.

--
The Quick Shield: breakout all 28 pins to quick-connect terminals
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 32
Arduino rocks
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Ok, I'll make the full schematic to post here... I think that you can help me with this, and I understand that is not easy to help without something to look into.

When I finish, I'll post here, ok?
I hope you can help me.
Logged

Visit my website: http://ricardo-dias.com/ for Arduinos and other stuff! smiley

0
Offline Offline
Newbie
*
Karma: 0
Posts: 32
Arduino rocks
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Here is the full schematic:
http://img299.imageshack.us/img299/1084/imagem4jn.png

PROBE goes to one analog pin, to measure the aproximate battery voltage. (not being done right now)
Logged

Visit my website: http://ricardo-dias.com/ for Arduinos and other stuff! smiley

Pages: 1 [2]   Go Up
Jump to: