Go Down

Topic: Problems burning bootloader with Uno (Read 1 time) previous topic - next topic

Jarkman

I have a shiny new Uno and an install of 0021, which has already run a couple of sketches (so I know it works correctly).

When I put a blank 328 in the Uno, and select Tools / Burn Bootloader / w/Arduino as ISP, nothing happens for 22 seconds. Then I get this:

avrdude: stk500_getsync(): not in sync: resp = 00
avrdude: stk500_disable(): protocol error: expect=0x14, resp=0x51

Is there anything I can do to troubleshoot this ?
I'm on XP, if that makes any difference.

Thanks,

Richard

Jarkman

Aha - this doesn't work on an Uno, apparently:

http://arduino.cc/en/Tutorial/ArduinoISP

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy