Go Down

Topic: AT90CAN128 and Arduino (Read 597 times) previous topic - next topic

endoracing

Hello,

I am trying to use an Olimex AT90CAN128 development board with the Arduino IDE 0021 with no luck. I am using the files from this thread:

http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1268833401/5

So far I have had no luck and I am wondering if anyone has any experience with this and was able to get it working... Any help is appreciated. I also have an at90can128 header board that I cannot get to work correctly either.

So far I am able to compile and upload sketches to the board, but even something simple like blinking the LED on pin 6 does not run. The sample .hex from olimex does work to blink the LED, so I know that it is not just the board.

Thanks,
Jeff

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy