Go Down

Topic: avrdude: stk500_getsync(): not in sync: resp=0x00 (Read 291617 times) previous topic - next topic

spix

I have just solve this Problem!!!!
I have downloaded the Arduino Software.
then I have gone to system/Device Manager/USB-Uart with a ?.
then I Have Installed the USB Driver that you find it in the Downloaded Arduino Folder.
all Problems Solved.
I´m Happy  ;D ::)

abner

I have meeted this issue[ch65292]i spend two dayes[ch65292]finally[ch65292]refresh 168 bootloader[ch65292]it works OK ;D


avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51



For fixing this, "unplug" the connected wire from RX0 (Pin0) > upload the code> "Plug" that wire again. :D

For fixing this, "unplug" the connected wire from RX0 (Pin0) > upload the code> "Plug" that wire again. :D

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy