Go Down

Topic: TQFP or 32MLF package for ATmega328P? (Read 3843 times) previous topic - next topic

ionito

I am making the last adjustments at my design and I had to move from PDIP (28-pin) to TQFP (32-pin) package due to the need of ADC pins. The additional pins allow the use of ADC 6 and 7.

However, I also observed in the datasheet of the MCU that the 32MLF version is also available, instead of TQFP version. The MLF has the bottom to be soldered to ground... I do not need and want to do so.

Therefore, I intend to go to the TQFP direction. Does anyone have an experience or advise to not doing so?Any comments are very appreciated.

Thanks

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy