Pages: [1]   Go Down
Author Topic: TQFP or 32MLF package for ATmega328P?  (Read 3537 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
Karma: 1
Posts: 111
... only learning ...
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am making the last adjustments at my design and I had to move from PDIP (28-pin) to TQFP (32-pin) package due to the need of ADC pins. The additional pins allow the use of ADC 6 and 7.

However, I also observed in the datasheet of the MCU that the 32MLF version is also available, instead of TQFP version. The MLF has the bottom to be soldered to ground... I do not need and want to do so.

Therefore, I intend to go to the TQFP direction. Does anyone have an experience or advise to not doing so?Any comments are very appreciated.


Pages: [1]   Go Up
Jump to: